AJ's 'Hurst' Jeepster Buildup ^Featured

I found this "Hurst" Jeepster in the summer of 04. It was about 2 blocks away from where I had just moved in. I had always liked Jeepsters because I had grown up with a 67 convertible. I saw the hood tach and where it looked to be a hood scoop...

| 1710 hits | Read more

GM Alternator

I just installed a GM 78 amp alternator kit, on my 1.3 L. Its was a very simple install even with all the grinding that is required. There are several companies that you can purchase an entire kit from or you can buy it in pieces and put...

| 1374 hits | Read more

High Clearance Transmission Crossmember

Binding your shaft? Want to put a better shaft up front on your Suzuki Samurai? Now you can! Tonight we installed a high clearance transmission crossmember from Rock 4x Fabrication on our Samurai. The following is how I installed it......

| 983 hits | Read more

JKS Quick Disonnects on a ZJ

Any Jeep owner that hits the trail very often can tell you that a swaybar quick disconnects are a must. While swaybars do a good job of stabilizing your Jeep while on the road, they do limit the amount of wheel travel you get while out...

| 241 hits | Read more

Rocky Road Coil Suspension ^Featured

The coil kit does require cutting and welding and should be installed by those with enough experience to competently handle these jobs. You should plan on having the vehicle down for a day and perhaps two depending on how meticulous you wish...

| 2350 hits | Read more

Rocky Road Power Steering

Here is an overview of the Toyota power steering install I did using Rocky Road Outfitters bracket kit. I used the kit that uses the AC compressor as an idler because I plan on eventually converting my AC compressor to on-board air. As...

| 962 hits | Read more

Tracker/Sidekick Rear Seat Belts

Materials needed: Roll / Sport cage with rear family hoop Geo Tracker / Suzuki Sidekick (2 door) rear seat belts and buckles with original hardware Some minor fabricating skills and welder or a good sheet metal shop (I used the latter)...

| 1802 hits | Read more

Transfer Case Shifter 'Sheet' Bushing ^Featured

Have you ever been on the trail and your transfer case shifter gets stuck in neutral? Unfortunately you aren't the only one. This is very common among Samurais. The cause for this is a little shifter bushing that is inside the top of the...

| 1048 hits | Read more